SENSe Subsystem 10
Keysight N8262A Programming Guide 343
[SENSe] Subsystem
The SENSe command subsystem directly affects device specific settings used to
make measurements. The SENSe subsystem is optional since this is the primary
function of the power meter. The high level command CONFigure uses the SENSe
commands to prepare the p ower meter for making measurements. At a lower
level SENSe enables you to change the following parameters: RANGe, FREQuency,
LOSS, CFACator|GAIN1 (calibration factor), GAIN2 (channel offset), DCYCle (duty
cycle) and AVERage, without completely re-configuring the power meter.
The SENSe command subsystem also allows you to select the measurement
speed, a sensor calibration table, and a frequency dependent offset table.
The numeric suffix of the SENSe program mnemonic in the SENSe commands refers
to a channel, that is SENSe1 and SENSe2 represent Channel A and Channel B
respectively.
Keyword Parameter Form Notes Page
[SENSe[1]]|SENSe2
:AVERage
:COUNt <numeric_value> page 347
:AUTO <boolean> page 350
:SDETect <boolean> [non-SCPI] page 353
[:STATe] <boolean> page 355
:AVERage2
:COUNt <numeric_value> page 358
[:STATe] <boolean> page 360
:BANDwidth|BWIDth
:VIDeo <character_data> page 362
:CORRection
:CFACtor|GAIN[1] [non-SCPI]
[:INPut]
[:MAGNitude] <numeric_value> page 365
To Next Page
Loading...
Need help?
General
