SENSe Subsystem 10
Keysight N8262A Programming Guide 355
[SENSe[1]]|SENSe2:AVERage[:STATe] <boolean>
This command is used to enable and disable averaging.
Syntax
Example
Reset Condition
On reset, averaging is OFF.
Query
[SENSe[1]]|SENSe2:AVERage[:STATe]?
The query enters a 1 or 0 into the output buffer indicating the status of averaging.
– 1 is returned when averaging is enabled
– 0 is returned when averaging is disabled
AVER 1 This command enables averaging on
Channel A.
SENS
1
:STAT
AVER 0|OFF
1|ON
Space
?
SENS2
:
To Next Page
Loading...
