Keysight Technologies P Series User Manual

10 SENSe Subsystem
350 Keysight N8262A Programming Guide
[SENSe[1]]|SENSe2:AVERage:COUNt:AUTO <boolean>
This command enables and disables automatic averaging. ONCE has no affect on
the power meter.
When the auto filter mode is enabled, the power meter automatically sets the
number of readings averaged together to satisfy the averaging requirements for
most power measurements. The number of readings averaged together depends
on the resolution and the power level in which the power meter is currently
operating. Figure 10-1 is an example of the averaged number of readings for each
range and resolution when the power meter is in auto measurement average
mode and using a P-Series power sensor.
Setting this command to ON automatically sets the
[SENSe[1]]|SENSe2:AVERage:STATe command to ON.
Figure 10-1 Example of averaged readings
If [SENSe[1]]|SENSe2:AVERage:COUNt:AUTO is set to OFF, the filter length is set
by the [SENSe[1]]|SENSe2:AVERage:COUNt command. Using the
[SENSe[1]]|SENSe2:AVERage:COUNt command disables automatic averaging.
Auto averaging is enabled by the MEASure:POWer:AC? and CONFigure:POWer:AC?
commands.
10 dB
10 dB
Maximum Sensor Power
Minimum Sensor Power
Power Sensor Dynamic Range
10 dB
10 dB
1234
1118
Resolution Setting
Number of Averages
11116
11232
1 1 16 256
1 8 128 128

Keysight Technologies P Series Specifications

General

Brand	Keysight Technologies
Model	P Series
Category	Measuring Instruments
Language	English