2 MEASurement Commands
146 Keysight N8262A Programming Guide
FETCh[1]|2|3|4[:SCALar][:POWer:AC]?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window’s measurement function to single
channel with relative mode off, recalculates the measurement and places the
result on the bus. The result is a power based measurement and is expressed in
the units defined by UNIT[1]|2|3|4:POWer.
Syntax
Parameters
Refer to “Optional Parameters” on page 126 for additional details on the
parameters in this command.
:POW
:AC
?
:SCAL
Space
expected_value
DEF
resolution
,
DEF
source list
,
FETC
1
2
3
4
Item Description/Default Range of Values
expected_value
(for the expected power
level)
The expected power level parameter can be set to DEF or a
numeric value. If a value is entered it should correspond to that
set by CONFigure otherwise an error occurs. The units of
measurement are dBm and W. The default units are defined by
UNIT:POWer.
Sensor dependent
DEF
[a]
To Next Page
Loading...
Need help?
General
