11 STATus Subsystem
422 Keysight N8262A Programming Guide
Status Register Set Commands
This section describes the five status register set commands. Each can be used to
examine all of the eleven status registers listed on page 421.
To apply a command to a specific register, prefix the command with the name of
the appropriate register. For example, to apply the :ENABle command to the
STATus:QUEStionable register, use the following command:
STATus:QUEStionable:ENABle
The Status Register Set commands detailed in this section are:
:CONDition?
This query returns a 16 bit decimal-weighted number representing the bits set in
the Condition Register of the SCPI Register Set you require to control. The format
of the return is <NR1> in the range of 0 to 32767 (2
15
–1). The contents of the
Condition Register remain unchanged after it is read.
Syntax
Keyword Parameter Form Notes Page
:CONDition? [query only] page 422
:ENABle <NRf>|<non-decimal numeric> page 423
[:EVENt?] [query only] page 423
:NTRansition <NRf>|<non-decimal numeric> page 424
:PTRansition <NRf>|<non-decimal numeric> page 425
To Next Page
Loading...
Need help?
General
