SERVice Subsystem 16
Keysight N8262A Programming Guide 637
SERVice:SENSor[1]|2:POWer:AVERage:MAXimum?
This query returns the maximum average power that can be measured by the
currently connected sensor. It is applicable to E-Series sensors only. Maximum
average power information is stored in the sensor’s EEPROM.
Syntax
Example
Error Messages
– If no sensor is connected, error –241, “Hardware missing” occurs.
– If a a sensor other than an E-Series power sensor is connected, error –241
“Hardware missing” occurs.
– If the E-Series sensor currently connected does not contain the necessary
information in EEPROM, error –241 “Hardware missing” occurs.
SERV:SENS:POW:AVER:MAX? This query returns the maximum average
power that can be measured by the E-Series
sensor currently connected to Channel A.
:POW
?
:AVER
:MAX
SERV
1
2
:SENS
To Next Page
Loading...
