MEMory Subsystem 7
Keysight N8262A Programming Guide 311
Query Example
Error Messages
– If more than 81 calibration factors for sensor calibration tables, or 80 offsets
for frequency dependent offset tables are in the list, error –108, “Parameter not
allowed” occurs.
– If a table is not specified using the MEMory:TABLe:SELect command, the data
cannot be entered and error –221, “Settings conflict” occurs.
– If any of the calibration/offset factors are outside of the allowed range, error
–222, “Data out of range” occurs.
MEM:TABL:GAIN? This command queries the calibration factor/
offset in the current table.
To Next Page
Loading...
