Keysight Technologies P Series - Trigger Subsystem

Keysight N8262A P-Series Modular Power Meter
Programming Guide
565
14 TRIGger Subsystem
TRIGger Subsystem 566
ABORt[1]|2] 568
INITiate Commands 569
INITiate[1]|2:CONTinuous <boolean> 570
INITiate[1]|2[:IMMediate] 572
INITiate:CONTinuous:ALL <boolean> 573
INITiate:CONTinuous:SEQuence[1]|2 <boolean> 575
INITiate[:IMMediate]:ALL 577
INITiate[:IMMediate]:SEQuence[1]|2 578
TRIGger Commands 579
TRIGger[1]|2:DELay:AUTO <boolean> 580
TRIGger[1]|2[:IMMediate] 582
TRIGger[1]|2:SOURce BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2] 583
TRIGger[:SEQuence]:DELay <numeric_value> 586
TRIGger[:SEQuence]:HOLDoff <numeric_value> 588
TRIGger[:SEQuence]:HYSTeresis <numeric_value> 590
TRIGger[:SEQuence]:LEVel <numeric_value> 592
TRIGger[:SEQuence]:LEVel:AUTO <boolean> 594
TRIGger[:SEQuence]:SLOPe <character_data> 596
TRIGger[:SEQuence[1]|2]:COUNt <numeric_value> 597
TRIGger[:SEQuence[1]|2]:DELay:AUTO <boolean> 599
TRIGger[:SEQuence[1]|2]:IMMediate 601
TRIGger[:SEQuence[1]|2]:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2] 602
This chapter explains how the TRIGger command subsystem is used to
synchronize device actions with events.