CALCulate Subsystem 3
Keysight N8262A Programming Guide 219
Example
Query
CALCulate[1]|2|3|4:RELative[:MAGNitude]:AUTO?
The query always returns OFF.
Error Message
–If CALCulate:RELative[:MAGNitude]:AUTO is set to ONCE while
SENSe:SPEed is set to 200, error –221, “Settings Conflict” occurs.
– If the value is set to ON error –224, “Illegal parameter value” occurs.
CALC1:REL:AUTO ONCE This command sets a reference value to be
used in the relative measurement on the
upper window/upper measurement.
To Next Page
Loading...
