SENSe Subsystem 10
Keysight N8262A Programming Guide 403
Reset Condition
On reset, the delay is set to 0 seconds.
Query
SENSe[1]]|SENSe2:TRACe:OFFSet:TIME?
The query returns the current delay between the delayed trigger point and the
start of the trace.
Query Example
Error Messages
– If the command is used when a sensor other than a P-Series power sensor is
connected, error –241, “Hardware missing” occurs
SENS:TRAC:OFFS:TIME? This command queries the current delay
between the delayed trigger point and the
start of the trace for Channel A.
To Next Page
Loading...
