Keysight Technologies P Series - Output:recorder[1]|2:State <Boolean

OUTPut Subsystem 8
Keysight N8262A Programming Guide 323
OUTPut:RECorder[1]|2:STATe <boolean>
This command enables or disables the specified recorder output.
Syntax
Example
Reset Condition
On reset, the recorder output is OFF.
Query
OUTPut:RECorder[1]|2:STATe?
The query command enters a 1 or 0 into the output buffer indicating whether or
not the specified recorder is switched on.
– 1 is returned when the recorder output is switched ON
– 0 is returned when the recorder output is switched OFF
Query Example
OUTP:REC1:STAT 1 This command enables the specified
recorder output.
OUTP
:STAT
:REC
0|OFF
1|ON
Space
?
1
2
OUTP:REC2:STAT? This command queries the status of the
recorder output.