Keysight Technologies P Series

TRIGger Subsystem 14
Keysight N8262A Programming Guide 597
TRIGger[:SEQuence[1]|2]:COUNt <numeric_value>
This command controls the path of the trigger subsystem in the upward traverse
of the wait for trigger state. COUNt loops through the event detection/
measurement cycle are performed. That is, COUNt measurements are performed in
response to COUNt trigger events.
COUNt can be set to a value >1 only when:
– [SENSe[1]]|SENSe2:MRATe <character_data> is set to FAST
and
– TRIGger[1]|2:SOURce set to BUS, IMMediate or HOLD.
Syntax
Parameters
:COUN Space
?
numeric_value
DEF
TRIG
:SEQ
1
2
Item Description/Default Range of Values
numeric_value The number of triggered events for the measurement cycle.
– DEF: the default value is 1
1 to 50
DEF