Keysight Technologies P Series

SYSTem Subsystem 12
Keysight N8262A Programming Guide 511
892.11b/g
The following table shows the power meter presets when <character_data> is
set to 802DOT11B. Commands not listed are preset according to their DEFault
values (for further information refer to Table 12-1).
Table 12-28 802.11a and HiperLan2: Power meter presets for secondary channel sensors
Function Secondary Channel Sensor
No Sensor Non P-Series Sensor P-Series Sensor
Display setup
Upper window UU Single numeric Dual numeric Dual numeric
Lower window Dual numeric Dual numeric Dual numeric
Upper window/lower measurement (UL)
Feed DEF
Gate 1 primary channel
[a]
Gate1 primary channel
[a]
(Channel A)
Measurement DEF Peak Peak
Lower window/upper measurement (LU)
Feed
Gate 1 primary channel
[a]
Gate 1 primary channel
[a]
Gate 1 secondary channel
[a]
(Channel B)
Measurement Peak Pk-to-Avg Avg
Lower window/lower measurement (LL)
Feed
Gate 1 primary channel
[a]
Secondary channel
[a]
Gate 1 secondary channel
[a]
(Channel B)
Measurement Pk-to-Avg Avg Pk-to-Avg
[a] For further information refer to “Primary and Secondary Channels” on page 473.