Keysight Technologies P Series

SYSTem Subsystem 12
Keysight N8262A Programming Guide 505
RADAR
The following table shows the power meter presets when <character_data> is
set to RADar. Commands not listed are preset according to their DEFault values
(for further information refer to Table 12-1).
Measurement DEF Peak Peak
Lower window/upper measurement (LU)
Feed
Gate 1 primary channel
[a]
Gate 1 primary channel
[a]
Gate1 secondary channel
[a]
(Channel B)
Measurement Peak Pk-to-Avg Avg
Lower window/lower measurement (LL)
Feed
Gate 1 primary channel
[a]
Secondary channel
[a]
Gate1 secondary channel
[a]
(Channel B)
Measurement Pk-to-Avg Avg Pk-to-Avg
[a] For further information refer to “Primary and Secondary Channels” on page 473.
Table 12-22 MCPA: Power meter presets for secondary channel sensors (continued)
Function Secondary Channel Sensor
No Sensor Non P-Series Sensor P-Series Sensor
Table 12-23 RADAR: Power meter presets
Command Setting Comments
Frequency
[SENS[1]]|SENS2:FREQ[:CW|:FIX] +10.000 GHz Frequency setting
Sensor measurement mode
[SENS[1]]|SENS2:DET:FUNC NORM Measurement mode
Sensor video bandwidth setup
[SENS[1]]|SENS2:BAND|BWID:VID N1921/2A: OFF Sensor video bandwidth
Gate Setup