2 MEASurement Commands
144 Keysight N8262A Programming Guide
Example
[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command sub-systems. The parameters must
be entered in the specified order. If parameters are omitted, they default from the right. The parameter DEFault is used as a place holder.
Specifying DEF leaves the parameter value unchanged.
[b] When the measurement result is linear this parameter represents the number of significant digits. When the measurement result is
logarithmic 1 to 4 represents of 1, 0.1, 0.01 and 0.001 respectively.
CONF1:RAT:REL
DEF,1,(@1),(@2)
This command configures the upper window/
upper measurement to make a ratio
measurement of Channel A over Channel B
with relative mode on, using the current
sensor range and a resolution setting of 1 on
both channels.
To Next Page
Loading...
Need help?
General
