Keysight Technologies P Series User Manual

7 MEMory Subsystem
282 Keysight N8262A Programming Guide
MEMory Subsystem
The MEMory command subsystem is used to:
– Edit and review sensor calibration tables (8480 Series
sensors only)
– Store sensor calibration tables (8480 Series sensors only)
– Edit and review sensor frequency dependent offset tables
– Store sensor frequency dependent offset tables
– Edit and review sensor save/recall registers
Stored tables remain in the power meter’s memory during power down. The
power meter is capable of storing 20 sensor calibration tables and 10 frequency
dependent offset tables of 80 frequency points each.
NOTE
The MEMory subsystem is not used for E-Series and P-Series power sensors
calibration tables. These are automatically downloaded to the power meter and
cannot be reviewed or edited.
Keyword Parameter Form Notes Page
MEMory
:CATalog
[:ALL]? [query only] page 285
:STATe? [query only] page 287
:TABLe? [query only] page 288
:CLEar
[:NAME] <character_data> [no query],
[non-SCPI]
page 292
:TABLe [no query] page 294
:FREE
[:ALL]? [query only] page 296
:STATe? [query only] page 297

Keysight Technologies P Series Specifications

General

Brand	Keysight Technologies
Model	P Series
Category	Measuring Instruments
Language	English