Service
Tables
SERVICE PROGRAM MODE TABLES
SM 5-43 B079/B082
SP5 Mode Number Function and [Setting]
5501* 2* Original Count Alarm Sets the alarm to sound after the specified total
number of originals goes through the ARDF.
0: Disabled, 1: Enabled
0: No alarm sounds
1: Alarm sounds after the number of originals
passing through the ARDF ≥ 10,000
5504* Jam Alarm Sets the alarm to sound for the specified jam level
(document mis-feeds are not included). DFU
[0~3 / 3 / 1 step]
0: Zero (Off)
1: Low (1.5K jams)
2: Medium (3K jams)
3: High (6K jams)
5505* Error Alarm Sets the error alarm level. Japan only
[0~255 / 50 / 100 copies per step]
1* Paper Supply Alarm Switches the control call on/off for the paper
supply. DFU
0: Off, 1: On
0: No alarm.
1: Sets the alarm to sound for the specified
number transfer sheets for each paper size
(A3, A4, B4, B5, DLT, LG, LT, HLT)
2* Staple Supply Alarm Switches the control call on/off for the stapler
installed in the finisher. Japan only
0: Off, 1: On
0: No alarm
1: Alarm goes off for every 1K of staples used.
3* Toner Supply Alarm Switches the control call on/off for the toner end.
DFU
0: Off, 1: On
If you select “1” the alarm will sound when the
copier detects toner end.
128* Others
132* A3
133* A4
134* A5
141* B4
142* B5
160* DLT
164* LG
166* LT
5507*
172* HLT
The “Paper Supply Call Level: nn” SPs specify the
paper control call interval for the referenced paper
sizes. DFU
[00250 ~ 10000 / 1000 / 1 Step]
5508 CC Call
1* Jam Remains Enables/disables initiating a call for an unattended
paper jam.
[0~1/1/1]
0: Disable
1: Enable
To Next Page
Loading...
