SERVICE PROGRAM MODE TABLES
B079/B082 5-46 SM
SP5 Mode Number Function and [Setting]
3* Supply Use this to input the telephone number of your
supplier for consumables. Enter the number and
press #.
Press the
key to input a pause. Press the
“Clear modes” key to delete the telephone
number.
5812*
4* Operation Use this to input the service telephone. Enter the
number and press #.
Press the
key to input a pause. Press the
“Clear modes” key to delete the telephone
number.
1 CSS Function On/Off
Japan Only
0: Off, 1: On.
5816*
2 CE Call
Japan Only
0: Start, 1: Finish
5821* CSS PI Device Code Selects the PI device code. DFU
[0~4 / 0 / 1 step]
5824 NVRAM Data Upload Uploads the UP and SP mode data (except for
counters and the serial number) from NVRAM on
the control board to a flash memory card.
While using this SP mode, always keep the front
cover open. This prevents a software module
accessing the NVRAM during the upload.
5825 NVRAM Data Download Downloads the content of a flash memory card to
the NVRAM on the control board.
5828* Network Setting
12 Device Name Displays the device name used by the network in
the format RNPxxx… up to 48 characters.
66 Job Spooling Clear: Start
Time
This SP determines whether jobs spooled but not
printed when the machine was switched off are
printed the next time the machine is switched on.
[0~1 /1 /1]
0: Not printed at power on
1: Printed at power on
This SP is available only when job spooling is
enabled.
69 Job Spooling (Protocol) Switches job spooling off and on and allows
settings for job spooling protocols.
[0~1 / 1 / 1]
0: Off
1: On (All Active)
Protocols are enabled/disabled with bit switch
settings (0 = Off, 0 = On).
Bit0: LPR
Bit1: FPT
Bit2: IPP
Bit3: SMB
Bit4~Bit7: Reserved
74* Delete Password Execute to delete network password.
5828*
84* Print Settings List Prints a list of all network related parameters.
To Next Page
Loading...
