Service
Tables
SERVICE PROGRAM MODE TABLES
SM 5-57 B079/B082
SP5 Mode Number Function and [Setting]
9 Key 9 5859
10 Key 10
5907* Plug & Play Sets the brand name and the production name for
Windows Plug & Play. This information is stored in
NVRAM. If the NVRAM is defective or has been
replaced, these names should be registered
again.
To set the plug and play model name, enter the
model number, and then press
.
5913 Switchover Permission Time Initial: 3
Application Counter Display Selects whether or not the total printer counter is
displayed in the UP mode.
Printer Counter 0: Off, 1: On
Fax Counter 0: Off, 1: On
5914*
Copy Counter 0: Off, 1: On
5915 Mechanical Counter Detection Checks whether the mechanical counter inside
the inner cover is connected or not.
Display:
0: Not detected
1: Detected
2: Unknown
5918* A3/DLT Counter Display Sets the key press display for the counter key.
[0, 1 / 0 / --]
This setting has no relation to (SSP) SP5-104
A3/DLT Double Count.
5923* Border Removal Area Switching Toggles between two settings that affect the
appearance of the pages for border removal and
printed facing pages: (1) Using the original area
as the allotted area, or (2) Using only the copy
paper as the allotted area.
[0, 1/ 0 / --]
0: Original area used as base
1: Copy used as the base
Feed Clutch Start Timing
Adjustment
Adjusts the clutch timing to optimize the intervals
between fed sheets to reduce jams in the feed
unit. DFU
1*
1st, 2nd Feed Clutches
2*
3rd, 4th, LCT Feed
Clutches
[35 ~ 57.5 / 42.5 / 2.5mm]
5958
3*
Leading Edge Jam
Detection Start Timing
[19~34 / 26.5 /2.5 mm]
To Next Page
Loading...
