"RemoteConnect Support" Settings
D0CA/D0C9/D0C8/D0CB 2-56 SM
"Check Status" menu or by pressing down on the status bar on the Smart Operation Panel
for over five seconds.
After pressing down for over five seconds, stop pressing on the panel and RemoteConnect
Support will open.
If setup was done correctly, four digits will be displayed on the panel. If the setup was not
done correctly, the four digits will not be displayed.
RemoteConnect Service requires an Internet connection, so the following error message
might appear after long-pressing the status bar if an Internet connection is not detected. To
check the connection, open the web browser in Smart Operation Panel and navigate to a
webpage to confirm that the machine is connected to the Internet.
• If the webpage cannot be connected, check the general network configuration settings,
such as the IP address and proxy settings.
To Next Page
Loading...
