Bit Switches – 1
D0CK 56 SM
System Switch 04 (SP No. 1-101-005)
No Function Comments
0-
2
Not used Do not change these settings.
3 Printing dedicated tx
parameters on Quick/Speed
Dial Lists
0: Disabled
1: Enabled
1: Each Quick/Speed dial number on the list is printed with the
dedicated tx parameters (10 bytes each).
The first 10 bytes of data are the programmed dedicated tx
parameters; 34 bytes of data are printed (the other 24 bytes
have no use for service technicians).
4-
7
Not used Do not change these settings.
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 (SP No. 1-101-010)
No Function Comments
0 Addition of image data from
confidential transmissions on the
transmission result report
0: Disabled 1: Enabled
If this feature is enabled, the top half of the first page of
confidential messages will be printed on transmission
result reports.
1 Print timing of communication
reports on the Journal when no
image data was exchanged.
0: After DCS/NSS communication
(default),
1: After polling
0: The Journal is printed only when image data is sent.
1: The Journal is printed when any data is sent.
2 Automatic error report printout
0: Disabled 1: Enabled
0: Error reports will not be printed.
1: Error reports will be printed automatically after failed
communications.
3 Printing of the error code on the
error report
0: No 1: Yes
1: Error codes are printed on the error reports.
This can be used for detecting an error which occurs
rarely.
4 Not used Do not change this setting.
5 Power failure report
0: Disabled
1: A power failure report will be automatically printed after
the power is switched on if a fax message disappeared
To Next Page
Loading...
