Bit Switches – 1
SM 57 D0CK
1: Enabled (default) from the memory when the power was turned off last.
NOTE: If "0" is selected, no reports are printed and no
one may recognize that fax data is gone due to a power
failure.
6 Conditions for printing the protocol
dump list
0: Print for all communications
1: Print only when there is a
communication error
This switch becomes effective only when system switch
00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol dump
list only for communications with errors.
NOTE: The memory size is limited. Use this bit switch
only when some log reports are necessary.
7 Not used Do not change this setting.
System Switch 0A (SP No. 1-101-011)
No Function Comments
0-
3
Not used Do not change these settings.
4 Dialing on the ten-key
pad when the external
telephone is off-hook
0: Disabled 1: Enabled
0: Prevents dialing from the ten-key pad while the external
telephone is off-hook. Use this setting when the external telephone
is not by the machine, or if a wireless telephone is connected as an
external telephone.
1: The user can dial on the machine's ten-key pad when the
handset is off-hook.
5 On hook dial
0: Disabled 1: Enabled
0: On hook dial is disabled.
6-
7
Not used Do not change these settings
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E (SP No. 1-101-015)
No Function Comments
0-
1
Not used Do not change the settings.
2 Enable/disable for direct
sending selection
0: Direct sending off
Direct sending cannot operate when the capture function is on
during sending. Setting this switch to "1" enables direct sending
without capture.
To Next Page
Loading...
