Bit Switches – 4
SM 91 D0CK
G3 Switch 0F (SP No. 1-105-016)
No Function Comments
0 Alarm when an error occurred in
Phase C or later
0: Disabled
1: Enabled
If the customer wants to hear an alarm after each error
communication, change this bit to "1".
1 Alarm when the handset is off-hook
at the end of communication
0: Disabled
1: Enabled
If the customer wants to hear an alarm if the handset is
off-hook at the end of fax communication, change this bit
to "1".
2-
3
Not used Do not change these settings.
4 Sidaa manual calibration setting
0: Off
1: On
1: manually calibrates for communication with a line
whose current change occurs such as an optical fiber line.
5-
7
Not used Do not change the settings.
To Next Page
Loading...
