Dehumidification Heater (PFU)
D0CA/D0C9/D0C8/D0CB 2-126 SM
8. Remove the switch cover [A]. (Hooks × 2)
9. Cut out the switch hole [A] in the switch cover.
10. Push the heater power switch to the switch cover.
11. Connect the heater power switch to the connectors of the junction harness [A].
Attach the rocker switch so that the white point [B] is on the upper side of the switch.
• A:Not used (For the drum heater: If
installing the anti-condensation heater
(H1))
• B:For the locker switch
• C:For the heater harness
• D:For the PSU (PCB17) (CN600)
To Next Page
Loading...
