SC6xx: Communication
D0CA/D0C9/D0C8/D0CB 6-56 SM
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC650-04 C Remote Service Modem Communication Error (dialup failing because of
incorrect modem configuration)
• An error related to communication (dialup connection, modem board etc.)
using the RC Gate Type M was detected or an error that prevents RC
Gate operation was detected at power on.
• Displayed only when an error is detected while RC Gate is operating.
• SC is not issued if an error occurs during RC Gate installation (because it
can be referenced using SP).
• SP settings invalid
• Modem connector disconnected
• Modem board disconnected
• Wireless LAN card disconnected
Software bug.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC650-05 C Remote Service Modem Communication Error (Insufficient Current or
Connection Fault)
• An error related to communication (dialup connection, modem board etc.)
using the RC Gate Type M was detected or an error that prevents RC
Gate operation was detected at power on.
• Displayed only when an error is detected while RC Gate is operating.
• SC is not issued if an error occurs during RC Gate installation (because it
can be referenced using SP).
• SP settings invalid
• Modem connector disconnected
• Modem board disconnected
• Wireless LAN card disconnected
The line is not supported and nothing can be done.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC650-13 C Remote Service Modem Communication Error (RC Gate Type M was
installed but modem is not present (detected during operation))
• An error related to communication (dialup connection, modem board etc.)
using the RC Gate Type M was detected or an error that prevents RC
Gate operation was detected at power on.
• Displayed only when an error is detected while RC Gate is operating.
• SC is not issued if an error occurs during RC Gate installation (because
this error can be referred by using SP).
To Next Page
Loading...
