EasyManua.ls Logo

Ricoh IM C300

Ricoh IM C300
1647 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SC8xx: Overall System
SM 6-107 D0CA/D0C9/D0C8/D0CB
Troubleshooting
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
When you do the above, the following information will be initialized.
Sender’s mail text
Default sender name/password (SMB/FTP/NCP)
Administrator mail address
Scanner delivery history
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC874-05 D Delete All Error (Delete Data Area) : Read error
SC874-06 D Delete All Error (Delete Data Area) : Write error
SC874-09 D Delete All Error (Delete Data Area) : No response from HDD
SC874-10 D Delete All Error (Delete Data Area) : Error in Kernel
SC874-12 D Delete All Error (Delete Data Area) : No designated partition
SC874-13 D Delete All Error (Delete Data Area) : No device file
SC874-14 D Delete All Error (Delete Data Area) : Start option error
SC874-15 D Delete All Error (Delete Data Area) : No designated sector number
SC874-16 D Delete All Error (Delete Data Area) : failure in performing hdderase
SC874-41 D Delete All Error (Delete Data Area) : Other fatal errors
SC874-42 D Delete All Error (Delete Data Area) : End by cancellation
SC874-61
to 65
D Delete All Error (Delete Data Area) : library error
SC874-66 D Delete All Error (Delete Data Area) : Unavailable
SC874-67 D Delete All Error (Delete Data Area) : Erasing not finished
SC874-68 D Delete All Error (Delete Data Area) : HDD format failure (Normal)
SC874-69 D Delete All Error (Delete Data Area) : HDD format failure (Abnormal)
SC874-70 D Delete All Error (Delete Data Area) : Unauthorized library
SC874-99 D Delete All Error (Delete Data Area) : other errors
An error occurred while data was being erased on HDD or NVRAM.
Error detected in HDD data delete program
Error detected in NVRAM data delete program
The “Delete All” option was not set
Turn the Main Power Switch (SW1) OFF and back ON, and then
execute "Erase All Memory" in UP mode again. (However, if there is a
defective sector or other problem with the hard disk, the error will persist
even after trying the above.)
If the "Delete All" option is not installed when this error occurs, install
the option.

Table of Contents

Related product manuals