SC8xx: Overall System
D0CA/D0C9/D0C8/D0CB 6-106 SM
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
the main power off/on. If SC occurs again, do the following steps.
1. After installing the HDD, or SD/USB ROM, execute SP5-846-046.
2. Wait more than 3 seconds, then execute SP5-832.
3. Cycle the main power OFF and ON.
Procedure after SC870 is cleared
1. If there is backup data in SD card or Web Image Monitor, restore the
address book data. (To restore from SD card, enter the encryption
password which is the same as when you enter to backup.)
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC871-00 D FCU Error
An error occurred when FCU defective.
• Time-out error
• Abnormal Parameter
1. Cycle the main power OFF and ON.
2. Update the firmware if more recent firmware was released.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC872-00 B HDD Mail Reception Error
An error was detected on the HDD immediately after the machine was turned
ON.
• HDD defective
• Power was turned OFF while the machine used the HDD.
1. Format the HDD (SP5-832-007).
2. Replace the HDD.
When you do the above, the following information will be initialized.
• Partly received partial mail messages.
• Already-read statuses of POP3-received messages (All messages on the
mail server are handled as new messages).
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC873-00 B HDD Mail Reception Error
An error was detected on the HDD immediately after the machine was turned
ON.
• HDD defective
• Power was turned OFF while the machine used the HDD.
1. Format the HDD (SP5-832-007).
2. Replace the HDD.
To Next Page
Loading...
