Jitter analysis and clock data recovery
R&S
®
RTP
1043User Manual 1337.9952.02 ─ 12
Access: "Analysis" menu > "Advanced Jitter" > "Result" tab > "Noise".
In the "Noise" tab, you can add the noise components you want to measure. You can
then enable a histogram, track or spectrum on them, see Component specific results.
Add / remove components
Opens a dialog to select the noise components.
Noise components
In the "Noise" tab, you can select which jitter noise components you want to measure.
Advanced jitter and noise (option R&S RTP- K133/K134)
To Next Page
Loading...
