Rohde & Schwarz RTP Series - Page 1280

Remote control commands
R&S
®
RTP
1280User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<ClockEdge> POSitive | NEGative | EITHer
See Chapter 22.4.3, "Slope parameter", on page 1147.
*RST: POSitive
Usage: Asynchronous command
TRIGger<m>:SPATtern:CSOurce:LEVel
<ClockLevel>
Defines the voltage level for the clock signal.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<ClockLevel> Range: -10 to 10
Increment: 1E-3
*RST: 0
Default unit: V
Usage: Asynchronous command
CDR:HARDware:SOURce <Source>
Selects the channel signal that is used for clock recovery.
The source cannot be changed if the serial pattern trigger is selected in the trigger
setup and the CDR is enabled. In this case, the instrument triggers on the recovered
clock, trigger source and CDR source are the same.
Parameters:
<Source> CHAN1 | C1 | CHAN2 | C2 | CHAN3 | C2 | CHAN4 | C4
*RST: CHAN1
Usage: Asynchronous command
CDR:HARDware:SERStandard <SerialStandard>
Sets the serial standard. Set CUSTOM to adjust the bit rate and the bandwidth manually.
Parameters:
<SerialStandard> CUSTOM | USB20 | USB31GEN1 | DISPPORT11 |
DISPPORT12 | FIBCHAN1 | FIBCHAN2 | FIBCHAN4 |
FIBCHAN8 | HDMI12 | HDMI14 | HDMI20 | PCIGEN1 |
PCIGEN2 | SATAGEN1 | SATAGEN2 | SATAGEN3 | SASGEN1 |
SASGEN2 | XAUI
*RST: CUSTOM
Trigger