Rohde & Schwarz RTP Series - Page 1378

Remote control commands
R&S
®
RTP
1378User Manual 1337.9952.02 ─ 12
MEASurement<m>:AMPTime:DATA<n>:LSELect <DatLevSel>
Selects the reference level of the data on which the setup and hold time are measured.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
<n> 1..2
The suffix is irrelevant, omit it.
Parameters:
<DatLevSel> UPPer | MIDDle | LOWer
*RST: MIDDle
Usage: Asynchronous command
MEASurement<m>:AMPTime:DTOTrigger<n>:SLOPe
<DlyTrigSlp>
Sets the edge direction to be used for delay measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
<n> 1..2
The suffix is irrelevant.
Parameters:
<DlyTrigSlp> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
MEASurement<m>:AMPTime:DTOTrigger<n>:LSELect <DlyTrigLevSel>
Selects the reference level of the measurement source on which the delay is mea-
sured.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
<n> 1..2
The suffix is irrelevant.
Parameters:
<DlyTrigLevSel> UPPer | MIDDle | LOWer
*RST: MIDDle
Usage: Asynchronous command
Automatic measurements