Rohde & Schwarz RTP Series - Page 1377

Remote control commands
R&S
®
RTP
1377User Manual 1337.9952.02 ─ 12
MEASurement<m>:AMPTime:ESLope <EdgesSlope>
Sets the edge direction to be counted: rising edges, falling edges, or both. The setting
is only relevant for edge count measurement (MEASurement<m>:MAIN EDGecount
or MEASurement<m>:ADDitional EDGecount,ON).
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<EdgesSlope> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
MEASurement<m>:AMPTime:CSLope
<SetHoldClkSlp>
Sets the edge of the clock from which the setup and hold times are measured.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<SetHoldClkSlp> POSitive | NEGative | EITHer
EITHer
The clock edges next to the data edge are considered regard-
less of the clock slope.
*RST: POSitive
Usage: Asynchronous command
MEASurement<m>:AMPTime:CLCK<n>:LSELect <ClkLevSel>
Selects the reference level of the clock on which the time is measured. Reference level
and clock slope define the time point for setup and hold measurements.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
<n> 1..2
The suffix is irrelevant, omit it.
Parameters:
<ClkLevSel> UPPer | MIDDle | LOWer
*RST: MIDDle
Usage: Asynchronous command
Automatic measurements