Rohde & Schwarz RTP Series - Page 1625

Remote control commands
R&S
®
RTP
1625User Manual 1337.9952.02 ─ 12
TRIGger<m>:CAN:DMAX <DataPatternTo>
Sets the the end value of an data range if TRIGger<m>:CAN:DCONdition is set to
INRange or OORange.
Parameters:
<DataPatternTo> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:CAN:BORDer <Endianness>
Sets the byte order (endianness) of the data transfer. Only for CAN protocol.
Parameters:
<Endianness> BENDian | LENDian
BENDian
Big endian, data is analyzed and evaluated in the order of
reception.
LENDian
Little endian, the instrument reads the complete data, reverses
the byte order of the data, and compares it with the specified
data word.
*RST: BENDian
TRIGger<m>:CAN:DLCCondition <DLCOperator>
Operator to set the data length code for triggering on CAN and CAN FD data.
For details, see "Data setup: DLC, NDB, Transfer, Condition, Data min, Data max"
on page 568.
The number of data bytes to be found is set with TRIGger<m>:CAN:DLC.
See also: TRIGger<m>:CAN:BORDer.
Parameters:
<DLCOperator> EQUal | GETHan
For little endian transfer direction, EQUal must be set.
*RST: GETHan
TRIGger<m>:CAN:DLC <WordCount>
Sets the Data Length Code, the number of data bytes to be found. For complete defini-
tion, set also the operator with TRIGger<m>:CAN:DLCCondition on page 1625.
Parameters:
<WordCount> Range: CAN: 1 to 8, CAN FD: 1 to 15 (64 bytes)
Increment: 1
*RST: 1
Protocols