Rohde & Schwarz RTP Series - Page 1689

Remote control commands
R&S
®
RTP
1689User Manual 1337.9952.02 ─ 12
TRIGger<m>:MILStd:MINGap:SELect............................................................................1696
TRIGger<m>:MILStd:STATus:BCReceived..................................................................... 1696
TRIGger<m>:MILStd:STATus:BUSY.............................................................................. 1696
TRIGger<m>:MILStd:STATus:DBCaccept.......................................................................1696
TRIGger<m>:MILStd:STATus:INSTrument......................................................................1697
TRIGger<m>:MILStd:STATus:MERRor...........................................................................1697
TRIGger<m>:MILStd:STATus:SREQuest........................................................................1697
TRIGger<m>:MILStd:STATus:SUBSystem......................................................................1697
TRIGger<m>:MILStd:STATus:TERMinal.........................................................................1697
TRIGger<m>:MILStd:TPSPecifier.................................................................................. 1697
TRIGger<m>:MILStd:TYPE <Type>
Sets the trigger type for MIL-1553 analysis.
Parameters:
<Type> STYPe | WTYPe | DATA | CDST | CMD | STATword | ERR
STYPe
SyncTYPe: triggers on a sync impulse.
WTYPe
WordTYPe: triggers on the selected word type.
DATA
Triggers on a data word that can be specified.
CDST
CommanDSTatus word: triggers on a command word or on a
status word that can be specified.
CMD
CoMmanD word: triggers on a command word or on a status
word that can be specified.
STATword
STATus word: triggers on a status word that can be specified.
ERR
ERRor: triggers on any combination of protocol errors.
*RST:
STYPe
TRIGger<m>:MILStd:DATA:RCONdition <RTAOperator>
TRIGger<m>:MILStd:CMD:RCONdition <RTAOperator>
TRIGger<m>:MILStd:CDST:RCONdition <RTAOperator>
Sets the operator to define a remote terminal address:
●
DATA: for data words
●
CMD: for command words
●
CDST: for status words
Parameters:
<RTAOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
Protocols