Rohde & Schwarz RTP Series - Page 1692

Remote control commands
R&S
®
RTP
1692User Manual 1337.9952.02 ─ 12
TRIGger<m>:MILStd:CMD:SMAX <SubaddrPattMax>
Sets the end value of the subaddress range if TRIGger<m>:MILStd:CMD:
SCONdition is set to INRange or OORange.
Parameters:
<SubaddrPattMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:CMD:SMIN <SubaddrPattMin>
Specifies a subaddress or sets the the start value of a subaddress range.
Parameters:
<SubaddrPattMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:CMD:TR <TRFlag>
Triggers on a transmission mode.
Parameters:
<TRFlag> ONE | ZERO | DC
ONE
Transmit direction.
ZERO
Receive direction.
DC
Either directions.
*RST: DC
TRIGger<m>:MILStd:CDST:ICONdition <InfoOperator>
Sets the operator to set a specific info for the 9th to 19th bit of a command or status
word.
Parameters:
<InfoOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with TRIGger<m>:MILStd:CDST:IMIN.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:MILStd:CDST:IMIN and
TRIGger<m>:MILStd:CDST:IMAX.
Protocols