Rohde & Schwarz RTP Series - Page 1691

Remote control commands
R&S
®
RTP
1691User Manual 1337.9952.02 ─ 12
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with TRIGger<m>:MILStd:CMD:CMIN.
INRange | OORange
In range/Out of range: Set the minimum and maximum value of
the range with TRIGger<m>:MILStd:CMD:CMIN and
TRIGger<m>:MILStd:CMD:CMAX.
*RST: EQUal
TRIGger<m>:MILStd:CMD:CMAX
<WordCntPattMax>
Sets the end value of a data word count/mode code pattern if TRIGger<m>:MILStd:
CMD:CCONdition is set to INRange or OORange.
Parameters:
<WordCntPattMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:CMD:CMIN <WordCntPattMin>
Specifies a data word count/mode code pattern or sets the the start value of a pattern
range.
Parameters:
<WordCntPattMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:CMD:SCONdition <SubaddrOperator>
Sets the operator to set a specific subaddress/mode pattern.
Parameters:
<SubaddrOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set withTRIGger<m>:MILStd:CMD:SMIN.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:MILStd:CMD:SMIN and
TRIGger<m>:MILStd:CMD:SMAX.
*RST: EQUal
Protocols