Rohde & Schwarz RTP Series - Page 1712

Remote control commands
R&S
®
RTP
1712User Manual 1337.9952.02 ─ 12
Parameters:
<BitRateMode> HIGH | LOW
*RST: HIGH
BUS<m>:ARINc:MAXGap:SELect <MaxGapSelect>
Enables the detection of the maximum gap time during decoding.
To specify the minimum gap time BUS<m>:ARINc:MINGap:BITS.
Suffix:
<m>
.
1..4
Parameters:
<MaxGapSelect> ON | OFF
*RST: OFF
BUS<m>:ARINc:MAXGap:BITS
<MaxGapBits>
Sets the value for the maximum gap between two words.
See also: BUS<m>:ARINc:MAXGap:SELect
Suffix:
<m>
.
1..4
Parameters:
<MaxGapBits> Range: 0 to 1000
Increment: 1
*RST: 100
Default unit: bit
BUS<m>:ARINc:MINGap:SELect <MinGapSelect>
Enables the detection of the minimum idle time between two words during decoding.
To specify the minimum gap, useBUS<m>:ARINc:MINGap:BITS.
Suffix:
<m>
.
1..4
Parameters:
<MinGapSelect> ON | OFF
*RST: ON
BUS<m>:ARINc:MINGap:BITS <MinGapBits>
Sets a value for the minimum timing gap between two words.
See also: BUS<m>:ARINc:MINGap:SELect on page 1712.
Suffix:
<m>
.
1..4
Protocols