Rohde & Schwarz RTP Series - Page 1751

Remote control commands
R&S
®
RTP
1751User Manual 1337.9952.02 ─ 12
BUS<m>:HBTO:FTYP..................................................................................................1752
BUS<m>:HBTO:RDAM.................................................................................................1752
BUS<m>:HBTO:RDAP................................................................................................. 1752
BUS<m>:HBTO:RDIF...................................................................................................1753
BUS<m>:HBTO:RTYP..................................................................................................1753
BUS<m>:HBTO:THReshold.......................................................................................... 1753
BUS<m>:HBTO:POLarity..............................................................................................1753
BUS<m>:HBTO:MODE.................................................................................................1753
BUS<m>:HBTO:SYMRate.............................................................................................1754
BUS<m>:HBTO:ATTN <Attenuation>
Sets the attenuation factor. It is used to de-amplify the reverse signal before subtract-
ing it from the forward signal.
Suffix:
<m>
.
1..4
Parameters:
<Attenuation> Range: -100 to 0
Increment: 0.1
*RST: -26
Default unit: dB
BUS<m>:HBTO:FDAM <SourceDAminus>
Selects the DA- source of the provided forward single ended signal, if BUS<m>:HBTO:
FTYP is set to SINGle.
Suffix:
<m>
.
1..4
Parameters:
<SourceDAminus> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
*RST: C2W1
BUS<m>:HBTO:FDAP <SourceDAplus>
Selects the DA+ source of the provided forward single ended signal, if BUS<m>:HBTO:
FTYP is set to SINGle.
Suffix:
<m>
.
1..4
Parameters:
<SourceDAplus> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
*RST: C1W1
Protocols