Rohde & Schwarz RTP Series - Page 1753

Remote control commands
R&S
®
RTP
1753User Manual 1337.9952.02 ─ 12
BUS<m>:HBTO:RDIF <SrcRevDiff>
Sets the source of the provided reversed differential signal, if BUS<m>:HBTO:RTYP is
set to DIFFerential.
Suffix:
<m>
.
1..4
Parameters:
<SrcRevDiff> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
BUS<m>:HBTO:RTYP <SignalRevType>
Sets the type of reverse signal measurement.
Suffix:
<m>
.
1..4
Parameters:
<SignalRevType> DISabled | DIFFerential | SINGle
*RST: DISabled
BUS<m>:HBTO:THReshold <ThresholdUpper>
Sets an user-defined threshold value.
Suffix:
<m>
.
1..4
Parameters:
<ThresholdUpper> Range: 0 to 2
Increment: 1E-3
*RST: 0.4
Default unit: V
BUS<m>:HBTO:POLarity <Polarity>
Selects the polarity of the data signal.
Suffix:
<m>
.
1..4
Parameters:
<Polarity> NORMal | INVert
*RST: NORMal
BUS<m>:HBTO:MODE <Mode>
Selects the direction of the full-duplex signal you want to look at.
Protocols