Rohde & Schwarz RTP Series - Page 1784

Remote control commands
R&S
®
RTP
1784User Manual 1337.9952.02 ─ 12
BUS<m>:TBTO:RESult:FRAMe<n>:STATe?................................................................... 1787
BUS<m>:TBTO:RESult:FRAMe<n>:STOP?....................................................................1788
BUS<m>:TBTO:RESult:FRAMe<n>:TYPE?....................................................................1788
BUS<m>:TBTO:RESult:FRAMe<n>:WORD<o>:TYPE?................................................... 1789
BUS<m>:TBTO:RESult:FRAMe<n>:WORD<o>:VALue?.................................................. 1789
BUS<m>:TBTO:RESult:FCOunt?
Returns the number of decoded frames.
Suffix:
<m>
.
1..4
Selects the serial bus.
Return values:
<FrameCount> Range: 0 to 100000
Increment: 1
*RST: 0
Usage: Query only
BUS<m>:TBTO:RESult:FRAMe<n>:BITRate?
Returns the primary bit rate.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<PrimaryBitRate> Range: 0 to 100000000000
Increment: 1
*RST: 0
Default unit: bps
Usage: Query only
BUS<m>:TBTO:RESult:FRAMe<n>:CRC?
Returns the CRC (frame check) checksum of the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Protocols