Rohde & Schwarz RTP Series - Page 1804

Remote control commands
R&S
®
RTP
1804User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:TBTO:LENGth:MIN <SearchName>,<TypePatternMin>
SEARch:TRIGger:TBTO:LENGth:MIN? <SearchName>
Specifies the length/ type bit pattern, or sets the start value of a pattern range.
Parameters:
<TypePatternMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (do not care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:TBTO:SADDress:CONDition
<SearchName>,<SrcAddrOperator>
SEARch:TRIGger:TBTO:SADDress:CONDition? <SearchName>
Sets the condition for the source address. You can define an exact value or a value
range.
Parameters:
<SrcAddrOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, not equal, less than, less or equal than, greater than,
greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIGger:TBTO:
SADDress:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:TBTO:SADDress:MIN
andSEARch:TRIGger:TBTO:SADDress:MAX.
*RST:
EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:TBTO:SADDress:MAX <SearchName>,<SrcAddrPattMax>
SEARch:TRIGger:TBTO:SADDress:MAX? <SearchName>
Sets the end value of the source address range if SEARch:TRIGger:TBTO:
SADDress:CONDition is set to INRange or OORange.
Parameters:
<SrcAddrPattMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (do not care).
Parameters for setting and query:
<SearchName>
Protocols