Rohde & Schwarz RTP Series - Page 1820

Remote control commands
R&S
®
RTP
1820User Manual 1337.9952.02 ─ 12
Parameters:
<AddressMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (do not care).
TRIGger<m>:RFFE:ADDRess:MAX <AddressMax>
Sets the end value of a range, if the data condition is set to INRange or OORange. See
TRIGger<m>:RFFE:ADDRess:CONDition.
Parameters:
<AddressMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (do not care).
TRIGger<m>:RFFE:BCOunt:CONDition <ByteCntOperator>
Sets the operator to trigger on a specific byte count or a byte count range.
Parameters:
<ByteCntOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater than,
Greater or equal than. These conditions require one pattern to
be set with TRIGger<m>:RFFE:BCOunt:MIN command.
INRange | OORange
In range / Out of range: Set the minimum and maximum value
using the corresponding TRIGger<m>:RFFE:BCOunt:MIN and
TRIGger<m>:RFFE:BCOunt:MAX
*RST: EQUal
TRIGger<m>:RFFE:BCOunt:MIN <ByteCountMin>
Specifies a pattern, or sets the start value of a pattern range.
Parameters:
<ByteCountMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (do not care).
TRIGger<m>:RFFE:BCOunt:MAX <ByteCountMax>
Sets the end value of a range, if the byte/bit count condition is set to INRange or
OORange. See TRIGger<m>:RFFE:BCOunt:CONDition.
Protocols