Rohde & Schwarz RTP Series - Page 1890

Remote control commands
R&S
®
RTP
1890User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..3
Parameters:
<PACPBEGINMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MPHY:PBEGin:MAX <PACPBEGINMax>
Sets the end value of the PACP Begin range if TRIGger<m>:MPHY:PBEGin:
CONDition is set to INRange or OORange.
Suffix:
<m>
.
1..3
Parameters:
<PACPBEGINMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MPHY:PFID:CONDition <CondPACPFunc>
Sets the condition for PACP Function ID. You can define an exact value or a value
range.
Suffix:
<m>
.
1..3
Parameters:
<CondPACPFunc> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:MPHY:PFID:
MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:MPHY:PFID:MIN and
TRIGger<m>:MPHY:PFID:MAX.
*RST:
EQUal
TRIGger<m>:MPHY:PFID:MIN <PACPFunIDMin>
Specifies the PACP Function ID bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Protocols