Rohde & Schwarz RTP Series - Page 1900

Remote control commands
R&S
®
RTP
1900User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:MPHY:ERRor:SYMBol....................................................................... 1914
SEARch:TRIGger:MPHY:ERRor:UNKNown....................................................................1914
SEARch:TRIGger:MPHY:ERRor:LENGth........................................................................1915
SEARch:TRIGger:MPHY:TYPE <SearchName>,<Type>
SEARch:TRIGger:MPHY:TYPE? <SearchName>
Selects the type of frame to be searched for.
Parameters:
<Type> START | BURST | ADAPT | LCC | DLPDUSOF | DLPDUCOF |
DLPDUEOF | DLPDUNAC | DLPDUAFC | PACP | TRIGUPR0 |
TRIGUPR1 | TRIGUPR2 | ERRor
START
M-PHY or UniPro start of frame.
BURST
M-PHY burst frame.
ADAPT
M-PHY Adapt frame. This control frame is used for clock/bit syn-
chronization.
LCC
M-PHY LCC frame. This control frame is used for line configura-
tion depending on the LCC Type.
DLPDUSOF | DLPDUCOF | DLPDUEOF | DLPDUNAC |
DLPDUAFC
UniPro DL PDU frame.
PACP
UniPro PACP frame. This control frame is used mainly for power
mode change and L1.5 link management.
TRIGUPR0 | TRIGUPR1 | TRIGUPR2
UniPro Trigger Upper frame. This control frame is used for link
startup sequence.
ERRor
M-PHY or UniPro error frame.
*RST:
START
Parameters for setting and query:
<SearchName>
Protocols