Rohde & Schwarz RTP Series - Page 1941

Remote control commands
R&S
®
RTP
1941User Manual 1337.9952.02 ─ 12
BUS<m>:CMSB:BITRate:ENABle <BitrateEnable>
Enables the bit rate settings (must always be enabled for the coding standard "NRZ
Unclocked", and also for triggering on signals in any coding standard).
Suffix:
<m>
.
1..4
Parameters:
<BitrateEnable> ON | OFF
ON
Bit rate settings enabled
OFF
Bit rate settings disabled
*RST: OFF
BUS<m>:CMSB:BITRate:VALue
<Bitrate>
Sets the transmission speed setting for the custom serial bus data signal.
Suffix:
<m>
.
1..4
Parameters:
<Bitrate> Range: 300 to 2E9
Increment: 100E3
*RST: 10E6
Default unit: bps
BUS<m>:CMSB:GAPTime:ENABle <GapTimeEnable>
Enables the gap time settings (must always be enabled for the coding standard "NRZ
Unclocked", and also for triggering on signals in any coding standard).
Suffix:
<m>
.
1..4
Parameters:
<GapTimeEnable> ON | OFF
ON
Gap time settings enabled
OFF
Gap time settings disabled
*RST: OFF
BUS<m>:CMSB:GAPTime:VALue <MinGapTime>
Sets a minimum gap time for synchronization.
Suffix:
<m>
.
1..4
Protocols