Rohde & Schwarz RTP Series - Page 1954

Remote control commands
R&S
®
RTP
1954User Manual 1337.9952.02 ─ 12
<n> *
Parameters:
<Enable> ON | OFF
*RST: ON
BUS<m>:CMSB:FILTer:FRAMe<n>:ENABle <Enable>
Enables or disables the specific frame to be filtered.
Suffix:
<m>
.
1..4
<n> *
Parameters:
<Enable> ON | OFF
*RST: OFF
BUS<m>:CMSB:FILTer:FRENable <Frame>, <Enabler>
Enables or disables the specific frame to be filtered.
Suffix:
<m>
.
1..4
Setting parameters:
<Frame>
<Enabler> ON | OFF
Usage: Setting only
BUS<m>:CMSB:FILTer:FIENable <Frame>, <Field>, <Enabler>
Enables or disables the specific field within the defined frame to be filtered.
Suffix:
<m>
.
1..4
Setting parameters:
<Frame>
<Field>
<Enabler> ON | OFF
Usage: Setting only
BUS<m>:CMSB:FILTer:FRAMe<n>:FLD<o>:BIT <BitState>
Sets the bit state of a field to be filtered on that only consists of one bit.
Protocols