Remote control commands
R&S
®
RTP
2013User Manual 1337.9952.02 ─ 12
*RST: OFF
TRIGger<m>:USB:FMIN <FrameNumber>
Specifies the frame number, or sets the the start value of a frame number range.
Parameters:
<FrameNumber>
TRIGger<m>:USB:FMAX <FrameNumberTo>
Sets the the end value of a frame number range if TRIGger<m>:USB:FCONdition is
set to INRange or OORange.
Parameters:
<FrameNumberTo>
TRIGger<m>:USB:HAND
<HandshakeType>
Sets the trigger to one out of four different handshake types: ACK, NAK, STALl, or
NYET.
Parameters:
<HandshakeType> ACK | NAK | STALl | NYET
ACK
Sets the trigger to the ACK field (acknowledgment of error-free
data packet).
NAK
Sets the trigger to the NAK field (non-acknowledgment, no suc-
cessful data transmission).
STALl
Sets the trigger to the STALL field (endpoint is halted or a con-
trol pipe request is not supported).
NYET
Sets the trigger to the NYET field (no response yet from
receiver).
*RST:
ACK
TRIGger<m>:USB:PATT <PayloadMuster>
Specifies the payload data pattern that is to be searched.
Parameters:
<PayloadMuster>
Protocols
To Next Page
Loading...
Need help?
General
