Rohde & Schwarz RTP Series - Page 2018

Remote control commands
R&S
®
RTP
2018User Manual 1337.9952.02 ─ 12
Parameters:
<PayloadCheck> ON | OFF
*RST: OFF
TRIGger<m>:USB:WPID <WithPIDCheck>
Defines, whether the packet ID error check shall be activated or not.
Parameters:
<WithPIDCheck> ON | OFF
*RST: OFF
TRIGger<m>:USB:WPOR <WithPortCheck>
Defines, whether the port check shall be activated or not.
Parameters:
<WithPortCheck> ON | OFF
*RST: OFF
TRIGger<m>:USB:WSEU <WithSEUCheck>
Defines, whether the SEU check shall be activated or not.
For SEU, see "SEU" on page 818.
Parameters:
<WithSEUCheck> ON | OFF
*RST: OFF
TRIGger<m>:USB:WSTC <WithSCCheck>
Defines, whether the Start / Complete (SC) check shall be activated or not.
Parameters:
<WithSCCheck> ON | OFF
*RST: OFF
22.17.19.3 Decode results
In all BUS<m>:USB:PACKet<n> commands, the suffix <m> selects the serial bus and
the suffix <n> selects the packet number in the decode table.
► Query the status of packet #19: BUS:USB:PACKet19:STAT?
The result of this remote command query should be "OK".
Protocols