Rohde & Schwarz RTP Series - Page 2132

Remote control commands
R&S
®
RTP
2132User Manual 1337.9952.02 ─ 12
TRIGger<m>:PCIE:DLLP:FCTL:VCID <VirtualChnID>
Sets the virtual channel ID to be triggered on for the data link layer trigger.
Parameters:
<VirtualChnID> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:AUTH <Authorized>
Sets the authorized presence state to be triggered on for the data link layer trigger.
Parameters:
<Authorized> ANY | YES | NO
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:CRET
<CreditType>
Sets the credit type to be triggered on for the multi-root data link layer trigger.
Parameters:
<CreditType> ANY | DATA | HEADER
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:DVPT <DevicePortType>
Sets the device/port type to be triggered on for the data link layer trigger.
Parameters:
<DevicePortType> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN | EIGHT | NINE | TEN | ELEVEN | TWELVE |
THIRTEEN | FOURTEEN | FIFTEEN
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:HABS <VHAbsent>
Sets the state of the absent virtual hieararchies (VH) to be triggered on for the data link
layer trigger.
Parameters:
<VHAbsent> ANY | YES | NO
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:MIXT <MixedType>
Sets the mixed type presence state to be triggered on for the data link layer trigger.
Protocols