Rohde & Schwarz RTP Series - Page 2133

Remote control commands
R&S
®
RTP
2133User Manual 1337.9952.02 ─ 12
Parameters:
<MixedType> ANY | YES | NO
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:PHAS <Phase>
Sets the phase state to be triggered on for the data link layer trigger.
Parameters:
<Phase> ANY | YES | NO
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:RESA <ResetA>
Sets the on the value of the A bit to be triggered on for the data link layer trigger.
Parameters:
<ResetA> ANY | ACK | REQUEST
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:TLPT <TLPType>
Sets the multi-root type to be triggered on for the data link layer trigger.
Parameters:
<TLPType> ANY | P | NP | CPL
P
Posted credit.
NP
Non posted credit.
CL
Completion credit.
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:TYPE <Type>
Sets the multi-root type for the data link layer to be triggered on.
Parameters:
<Type> MRINIT | MRRESET | MRUPDATEFC | MRINITFC1 |
MRINITFC2
*RST: MRINIT
TRIGger<m>:PCIE:DLLP:MULT:VHFC <InitVHFC>
Sets the virtual hierarchies flow control presence state to be triggered on for the data
link layer trigger.
Protocols