Rohde & Schwarz RTP Series - Page 2134

Remote control commands
R&S
®
RTP
2134User Manual 1337.9952.02 ─ 12
Parameters:
<InitVHFC> ANY | YES | NO
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:VHGR <ResetVHGroup>
Sets the virtual hierarchies group to be triggered on for the data link layer trigger.
Parameters:
<ResetVHGroup> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN | EIGHT | NINE | TEN | ELEVEN | TWELVE |
THIRTEEN | FOURTEEN | FIFTEEN
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:VLNR
<VirtualLink>
Sets the virtual link (VL) number to be triggered on for the data link layer trigger.
Parameters:
<VirtualLink> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN
*RST: ANY
TRIGger<m>:PCIE:DLLP:POWM <PowerMngtType>
Sets the power management type to be triggered on for the data link layer trigger.
Parameters:
<PowerMngtType> ANY | ENTERL1 | ENTERL23 | ACTREQL1 | REQUESTACK
*RST: ANY
TRIGger<m>:PCIE:DLLP:SEQ <ACKNAKSequence>
Sets the sequence field, indicating what TLPs are affected by the ACK/NAK, to be trig-
gered on for the data link layer trigger.
Parameters:
<ACKNAKSequence>
TRIGger<m>:PCIE:DLLP:TYPE <Type>
Sets the DLLP t type to be triggered on for the data link layer trigger.
Parameters:
<Type> ANY | MRDLLP | ACK | NAK | INITFC1 | INITFC2 | UPDATEFC |
PM | VENDOR
*RST: ANY
Protocols